Vortex manual blender

PRE-INSTALLATION VORTEX EF2280 Reference Manual 6 Technical Support: 800.932.2774 9. INPUT PARALLEL PORT.Parallel logic input. 10. OUTPUT PARALLEL PORT.Parallel logic output. 11. EF BUS IN.Connects to EF BUS OUT of another EF2280. 12. EF BUS OUT.Connects to the EF BUS IN of another EF2280. 13. RS-232 S ERIAL PORT.Connect this to an optional RS-232 remote control device, Digital Vortex Mixer 88882009 & 88882010 In the United States: For customer service, call 1-800-766-7000 To fax an order, use 1-800-926-1166 To order online: thermofisher.com Find out more at thermofisher.com In Canada: For customer service, call 1-800-234-7437 To fax an order, use 1-800-463-2996 To order online: thermofisher.ca For Research Benchmark's BenchMixer™ Vortex Mixer and Mortexer™ Vortex Mixer are quiet, powerful, mixers designed for vortexing micro tubes of all sizes (0.4ml to 50ml and larger). It combines dynamic balance technology with an electronic speed control to provide smooth speed control and quiet operation with low excess vibration. These Vortex Mixers will The Fisher Scientific Fixed Speed Vortex Mixers are one touch units that are designed for high speed mixing. Starts mixing when the head is pressed down. Speed is fixed at full rpm to provide vigorous vortexing of samples. Description Part # Price Analog Vortex Mixer, 120V 02-215-365 $335.00 Fixed speed vortex mixer includes both cup head Heavy Duty Vortex Mixer, Standard or Advanced 72" (183cm) power cord (1) cup head (1) universal holder (1) universal holder cover (1) foam insert (1.5-2.0 mL microtubes, holds 38) Instruction manual Or Microplate Vortex Mixer, Standard or Advanced 72" (183cm) power cord (1) cup head (1) microplate holder, single Instruction manual Warranty Vortex Mixers. Vortex mixers are commonly used in laboratories to mix small liquid volumes for cell disruption or homogenization. The analog or digital vortex mixers precisely control the operational speed and time to achieve reproducible results. Named after the vortex created when pressure is applied to a rubber cup (attached to motor via a 3 Load the blender jar as indicated in the recipe 4. Attach the blender lid to the jar; ensure that it sits on the jar completely. 5. Turn on the main power switch located on the back of the blender motor base in the lower right corner 6. Place the blender jar onto the base, making sure the jar is secure and fully seated on the motor base Operating the Vortex Mixer All operating controls are located on the front panel. The power switch, located on the left side of the panel, has three positions - TOUCH, OFF and ON. When set to the TOUCH position, the mixer is activated by depressing the mixing head. When pressure is released from the mixing head, opera- tion will stop. Basic Vortex Mixer 8 Step1 Step2 Installation of Microplate Tray Microplate Tray are suitable for "continuous" mode and samples are mixed with enzyme ELISA PLATE. 1. Parallel place the Microplate Tray on the top of the base tray. 2. The Fixed Speed Vortex Mixer runs only at 3200rpm (2500rpm for 230V). 1. Plug the power cord into a properly grounded outlet. The unit is now on and in a standby mode. 2.The vessel you are using must be pushed down on the head attachment to achieve motion. To get the desired mix, vary the angle of contact and pressure against the head. 3. Vortex Mixer complete with cup head * 1 2 . Power cable 1 . 3 . Instruction manual 1 * Two different models are available with the following product co