Cisco aironet 1200 series access point hardware installation guide

Hardware Installation Guide for Cisco Aironet 1200 Series Access Points Running VxWorks, OL-2155-02 Basic Configuration This chapter describes the initial configuration of the access point using the Internet browser-based management system and the serial interface. You can also reach the management system through a Telnet session. filexlib. Cisco Aironet 1200 Series Access Point Hardware Installation Guide DHCP-assigned IP address. To change the access point IP address from the default value using IPSU, refer to the "Using IPSU to Set the Access Point's IP Address and SSID" section on page 3-11. Cisco Aironet 1200 Series Access Point Hardware Installation Guide 3-10 OL-4310-01 Page 43: Using Ipsu To Set The Access Point's Ip Address And Ssid
Hardware Installation Guide for Cisco Aironet 1200 Series Access Points Running VxWorks, OL-2155-02 Declaration of Conformity and Regulatory Information Declarations of Conformity and Regulatory Information This appendix provides declarations of conformity and regulatory information for the Cisco Aironet 1200 Series Access Points.
This chapter lists the 1100 series lightweight (AIR-LAP1121G) access point IEEE 802.11b (2.4-GHz) and IEEE 802.11g (2.4-GHz) channels and the maximum power levels supported by the world's regulatory domains. For additional product hardware information refer to the Cisco Aironet 1100 Series Access Point Hardware Installation Guide. Step 1 Use the mounting bracket as a template to mark six screw hole locations on the mounting wall. The mounting bracket screw hole locations and the dimensions of the mounting bracket are shown in Figure 2-4. Step 2 Use six screws and, if required, wall anchors to attach the mounting plate to the mounting surface.
This chapter describes the setup of the access point and includes the following sections: • Safety Information • Warnings • Installation Guidelines • Unpacking the Access Point • Before Beginning the Installation • Installation Summary • Connecting the 2.4-GHz Antennas • Connecting the Ethernet and Power Cables. Safety Information
I got a new STANDALONE Aironet 1260 series access point device. The part # AIR-AP1262N-A-K9. The shipping package did not come with any guide, CD, and power adapter. I searched the Cisco sites, but could not find appropriate manuals. I did find a getting started guide but not for standalone AP, it's for Controller-based AP.
Cisco Aironet 1200 Series Install and Upgrade Published On: August 6ᵗʰ, 2019 02:02 Hardware Installation Guide for Cisco Aironet 1200 Series Access Points Running VxWorks, OL-2155-02 Console Cable Pinouts Console Cable Pinouts This appendix identifies the pinouts for the serial console cable that connects to the access point's serial console port.
Install and Upgrade Guides Cisco Aironet 1540 Series Outdoor Access Points Hardware Installation Guide Bias-Free Language Translations Updated: June 23, 2021 Book Table of Contents Preface Overview Installing the Access Point Troubleshooting Safety Guidelines and Warnings Declarations of Conformity and Regulatory Information Access Point Pinouts
Step 1 Unpack and remove the access point and the accessory kit from the shipping box. Step 2 Return any packing material to the shipping container and save it for future use. Step 3 Verify that you have received the items listed below. If any item is missing or damaged, contact your Cisco representative or reseller for instructions.
Lightweight Access Point. Aironet 1260 Series wireless access point pdf manual download. Sign In. Upload. Download Contents Table of Contents. H