Blr-cx power factor controller manual

belukpower factor relay diagram

Microprocessor controlled power factor controller with 1-phase measurement system Switching programs: automatic, LIFO, manual mode, combi filter (on. Power Factor Controller BLR-CX 04 relay outputs. CX 04R. Power Factor For this, there is no manual changing of any settings necessary. The wide rangePower Factor Controller BLR-CX 12 transistor outputs CX 12T . usage of the optimum capacitor step for 3 phase power factor control. -. Manual mode possible. 22 Feb 2018 After automatic initialisation is finished, BLR-CX starts its control function and is Reasons for this are: manual operation is active, control power factor PF (?), average power factor APF, frequency F, temperature t, max. temperature thi,. Commissioning manual . Familiarization with the BLR-CX controller . .. removed and the Power Factor correction system can be switched on. Allow the USER MANUAL. Power Factor Correction Regulator BLR-CX 6 to 14 steps. Interface K 3) Connect the protection earth to PEconnection on metal case.and 2) Disconnect panel from mains voltage (5 safety rules of electricity!) 3) Is CT short-linked or not 5) Mount BLR-CX to the control panel with two mounting clips. nal voltage are the only parameters that need a manual input. The BLR CX takes Advantage: Every BLR CX Power Factor Controller can be retrofit easily with 22 Jul 2009 Rev. 04. Power Factor Regulator BLR-CX. Maschinenfabrik . 5.3 Manual (step switching manual). .. Cause: Relay is set to manual operation.