2gig lan gc3 manual

A. GC3 panels must be running version 3.0.2 or higher. GC3 panels can be updated by pushing a firmware update from the Alarm.com dealer portal or by using a USB drive to update the panel while on site. Instructions for updating via USB are available on the 2GIG dealer site. Pricing The 2GIG SP2 MSRP is $230.23. Product Availability Unplug the transformer Loosen set screw on bottom of panel (does not come out all the way) Remove panel from wall by pulling on bottom 2 corners Hang panel from wall mount with white strap Disconnect panel battery Let sit for 20-30 seconds Plug battery back in, making sure wire is tucked into the panel The 2GIG GC3 Cellular Radio Module (sold separately) is a snap-in unit providing the GC3 Security & Automation System with communication to the Central Station for alarm signaling and delivering (Over-the-Air) OTA firmware updates to the GC3 Panel. It also provides connectivity to the Remote Service Provider and 2-way voice communication. 2GIG GC3 Control Panel. Rated 5.00 out of 5 based on 1 customer rating. ( 1 customer review) $ 400.00. The 2GIG GC3 Control Panel was 2GIGs first 7″ touchscreen system with Wi-Fi. It has since come out with a GC3E and then replaced that with the 2GIG Edge. It has a 7" color, capacitive touch screen, and a full upgrade to the user interface. The easiest, most intuitive experience of any security system in the industry. Panel 7″ capacitive touchscreen - larger screen allows for larger buttons and controls; easier to see and use Resolution: 800 x 480 pixels One-touch arming - Arm button on home screen for one-touch arming Capacitive-touch buttons - Home, Emergency Dimensions: 8.9″ x 5.25″ […] 2. Verify module & XCVR2 radio installation- Ensure that the communication module and XCVR2 radio are connected and installed properly inside the control panel. 3. Register Module and Test- Power up the panel and initiate a cell phone test to ensure the communication module is properly installed and communicating with Alarm.com. 4. To connect your 2GIG GC3 panel to your home WiFi. Enter your master code for the panel. A list of available networks will be displayed. Tap Network to connect to. Enter network password and tap Next. You will see the IP Address and other network information. While in AUTO the fields below will be blank. Alarm. 11. Add New User Code (remotely) Set up Alarm.com with Google Home. Clear "Panel Tamper" on a 2GIG GC2. Sensor Activity Notifications. Login - Create Additional Logins. Login permissions. Sensor in Malfunction. AAlarm Sounder and Speaker Sounds all system local alarms, voice prompts, system sounds, and audio for 2‐way voice communications with the Central Station BColor Display with Touchscreen Shows all system information, status, programming, and functions as the keypad. Display cycles clock, calendar, and weather (press manually to change) 2GIG-3GA-A-GC3US Only ADC - AT&T Cell Module • 3G (HSPA) cellular telephone module • Provides 2-way voice communication • Works on AT&T network • Plugs into GC3 panel • Compatible with Alarm.com • Built-in cell radio antenna PAGE 7 345 MHZ SENSORS (cont'd) 2GIG-KEY2-345 4-Button Key Ring Remote suretydiy.com/Running a cell phone test is not only needed to kick start your connection to suretyDIY service, but allows you to verify your cellular GC3 Verizon CellSled Cell Radio (ADC), US Only Features 3G (HSPA) cellular telephone module Provides 2-way voice communication Works on Verizon network Plugs into GC3 panel Compatib